Difference between revisions of "Spectranet ROM images"
| Line 1: | Line 1: | ||
== | == Installers == | ||
This is probably what you've come here looking for, especially if you had a firmware upgrade go bad. | |||
If you can't get to the Spectrum copyright message because your Spectranet has bad firmware, close jumper J2 to disable the automatic page-in, then reset your Spectrum. You can then send the TZX or TAP file via an audio cable and reprogram the Spectranet. | |||
[[ | TAP and TZX files: | ||
CLEAR 26999 | |||
LOAD "" CODE | |||
(play the TAP or TZX file to the Spectrum) | |||
RANDOMIZE USR 27000 | |||
* [http://spectrum.alioth.net/downloads/installer.tap Latest firmware - TAP format] | |||
* [http://spectrum.alioth.net/downloads/installer.tzx Latest firmware - TZX format] | |||
Binary files: | |||
You can use the [[ethup]] tool to send the binary image to a Spectrum if your Spectranet is working. You can also load it with the %aload command from a filesystem. | |||
CLEAR 26999 | |||
(send the binary image) | |||
RANDOMIZE USR 27000 | |||
* [http://spectrum.alioth.net/downloads/installer.bin Latest firmware - binary image] | |||
== Base system only installers == | |||
If you have a custom module setup, you might want to only install/update the base system and leave the modules untouched. The procedure is the same as for the above full installers. | |||
* [http://spectrum.alioth.net/downloads/baseinst.tap Latest base-only - TAP format] | |||
* [http://spectrum.alioth.net/downloads/baseinst.tzx Latest base-only - TZX format] | |||
* [http://spectrum.alioth.net/downloads/baseinst.bin Latest base-only - binary image] | |||
Back to [[Downloads]] | |||
[[Category:Spectranet]] | |||
Latest revision as of 20:25, 5 September 2012
Installers
This is probably what you've come here looking for, especially if you had a firmware upgrade go bad. If you can't get to the Spectrum copyright message because your Spectranet has bad firmware, close jumper J2 to disable the automatic page-in, then reset your Spectrum. You can then send the TZX or TAP file via an audio cable and reprogram the Spectranet.
TAP and TZX files:
CLEAR 26999 LOAD "" CODE (play the TAP or TZX file to the Spectrum) RANDOMIZE USR 27000
Binary files:
You can use the ethup tool to send the binary image to a Spectrum if your Spectranet is working. You can also load it with the %aload command from a filesystem.
CLEAR 26999 (send the binary image) RANDOMIZE USR 27000
Base system only installers
If you have a custom module setup, you might want to only install/update the base system and leave the modules untouched. The procedure is the same as for the above full installers.
Back to Downloads