Winston at 22:30, 27 August 2008

2008-08-27T22:30:51Z

← Older revision		Revision as of 23:30, 27 August 2008
Line 6:		Line 6:
	* If other peripherals are to be used at the same time - if they have their own ROM, they should be plugged into the Spectranet's through port, or else the Spectranet ROM and the other peripheral's ROM might get paged in at the same time, causing a crash.		* If other peripherals are to be used at the same time - if they have their own ROM, they should be plugged into the Spectranet's through port, or else the Spectranet ROM and the other peripheral's ROM might get paged in at the same time, causing a crash.
	* If you are using a +3 or late model +2, make sure J3 is jumpered. For other models, make sure J3 has no jumper.		* If you are using a +3 or late model +2, make sure J3 is jumpered. For other models, make sure J3 has no jumper.
			* The M1 line on your Spectrum '''must''' work. Some machines have faulty M1 lines. A working M1 line is essential for the Spectranet to be able to determine the CPU state.

	== Prototype / Development board: User guide ==		== Prototype / Development board: User guide ==
Line 13:		Line 14:
	* [[Hardware overview]] - Getting to know the hardware.		* [[Hardware overview]] - Getting to know the hardware.
	* [[Spectranet Configuration]] - Getting it set up on your network.		* [[Spectranet Configuration]] - Getting it set up on your network.
			* [[Troubleshooting]] - Some reasons why it might not work.

	[[Category:Spectranet]]		[[Category:Spectranet]]

Winston: New page: == Before you plug it in == The most important points to note: * Like any Spectrum peripheral, only connect it to the edge connector with the Spectrum powered off. (The ethernet port, ho...

2008-08-27T20:13:35Z

New page: == Before you plug it in == The most important points to note: * Like any Spectrum peripheral, only connect it to the edge connector with the Spectrum powered off. (The ethernet port, ho...

New page

== Before you plug it in ==

The most important points to note:

* Like any Spectrum peripheral, only connect it to the edge connector with the Spectrum powered off. (The ethernet port, however, is hot pluggable like any other ethernet port).
* If other peripherals are to be used at the same time - if they have their own ROM, they should be plugged into the Spectranet's through port, or else the Spectranet ROM and the other peripheral's ROM might get paged in at the same time, causing a crash.
* If you are using a +3 or late model +2, make sure J3 is jumpered. For other models, make sure J3 has no jumper.

== Prototype / Development board: User guide ==

The following short sections introduce the Spectranet, and provide a guide to getting it set up on your network.

* [[Hardware overview]] - Getting to know the hardware.
* [[Spectranet Configuration]] - Getting it set up on your network.

[[Category:Spectranet]]

User Guide - Revision history

Winston at 22:30, 27 August 2008

Winston: New page: == Before you plug it in == The most important points to note: * Like any Spectrum peripheral, only connect it to the edge connector with the Spectrum powered off. (The ethernet port, ho...